|
|
Industrial Applications CRYOFLEX™, a closed-cell Engineered Polymer Foam Insulation (EPFI), is supplied in block, sheet, spiral-formed tube, and extruded tube forms. It is a new insulation solution for applications that require flexibility in a cold environment. CRYOFLEX™ provides improved handling during installation and field fabrications using single seam clam shell application in standard pipe diameters. Applications CRYOFLEX™ is used to insulate industrial refrigeration systems. Its flexible, small, closed-cell features offer improved thermal conductivity and low moisture absorption and permeability. Designed for multilayered, pipe-covered nesting, CRYOFLEX™ provides the ability to build thick wall applications while avoiding the waste generated from typical large block fabrications. It also reduces the number of longitudinal seams, therefore allowing fewer paths for water ingress. CRYOFLEX™ is clean and resilient, It will not crack and break when installed in tight spots. CRYOFLEX™ is compatible with most thermo set resin adhesives, including vinyl esters and epoxies. Call Nomaco Insulation at 866-876-2684 for general guidelines and recommendations. CRYOFLEX™ exhibits the properties and characteristics indicated in Table 1 when tested as represented. A covering must be used to block ultraviolet radiation and prevent degradation. Other coverings to protect the foam from the elements and to meet applicable fire regulations may also be required. Consultation with local building code officials, design engineers/specifiers or insurance personnel is recommended before application. Environmental Data CRYOFLEX™ is specifically formulated to provide excellent thermal insulation properties. CRYOFLEX™ manufacturing chemistry is designed for energy conservation and does not harm the earth’s ozone layer. Fire Protection Consideration should be given to the benefits of and the costs of additional fire protection gained by installing automatic fire detection, alarm and suppression systems. Fabrication/Installation CRYOFLEX™ is easy to fabricate into various sizes and shapes to meet specific design needs. However, because of the critical technical design aspects of many of its applications, Nomaco Insulation recommends that qualified designers or consultants design the total system. Contact a local Nomaco Insulation representative for more specific instructions. Size Laminated Block Pipe Cover Wall thicknesses 1” (2.5cm) thru 6” (15.2 cm) |
|
||||||
| ® Copyright 2009-2010 Nomaco Insulation | marketing@nomacoinsulation.com | Privacy Policy |
